Skip to content

How To Straighten Pex Pipe

PEX pipe is a great alternative to traditional metal pipes, but it can often be difficult to get it perfectly straight. This guide will show you how to straighten PEX pipe using a few simple steps.

How To Straighten Pex Pipe

There are a few ways to straighten out PEX pipe. One way is to use a heat gun to heat up the pipe until it becomes malleable and then use a bending tool to shape it into the desired position. Another way is to use a clamp or vise to hold the pipe in place and then use a hammer to straighten it out.

-PEX pipe -Tape measure -Pipe cutter -Pipe wrench -Ruler or a straight edge

  • Turn on a faucet to release any pressure in the line
  • Use a pipe wrench to loosen the pex fittings on both ends of the pipe remove the pipe from the fitting
  • Turn off water supply valve

-check the pipe for kinks or bends before beginning -use a heat gun to slowly heat the pipe and straighten it out-use a pipe wrench to hold the pipe in place while straightening


Frequently Asked Questions

Can You Heat And Bend Pex?

PEX is a type of plumbing that can be heated and bent. PEX is less likely to corrode and is less likely to cause leaks than other types of plumbing.

How Do You Straighten Coiled Plastic Pipes?

The best way to straighten coiled plastic pipes is by using a snake or a special tool called a copper braid.

Can I Use A Heat Gun On Pex?

There is some debate over whether or not heat guns can be used on PEX piping. Some people claim that the heat will cause the piping to melt, while others say that the heat will only cause the insulation to melt and form a leak. It is best to consult with a professional if you are considering using a heat gun on PEX piping.

How Do You Straighten Pex Tubing?

There are various ways to straighten PEX tubing. One way is to use a gas-fired tube bender. This device can heat the tubing until it bends, then it cools the tubing so it snaps back into place.

Can I Use A Heat Gun To Straighten Pex?

Yes, you can use a heat gun to straighten PEX. However, be careful not to overheat the plastic and avoid using the heat gun near any electrical components.


Summing-Up

There are a few methods for straightening PEX pipe. One is to use a hammer and chisel to remove the bend, then use a snake or C-clamp to straighten the pipe. Another method is to heat the pipe until it softens, then use a vise to hold the pipe while you use a wrench to turn it.

Leave a Reply

Your email address will not be published. Required fields are marked *